Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL SUB TANK › from 2020.08
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260582 FUEL SUB TANK A

1GD-FTV FUEL  FUEL SUB TANK  INSTALLATION  


PROCEDURE

Hide 77269A 1.INSTALL FUEL TANK BREATHER HOSE

a.

Install the fuel tank breather hose to the fuel sub tank sub-assembly, and tighten the clamp to secure the hose.


Hide 77213B 2.INSTALL FUEL TANK TO FILLER PIPE HOSE

a.

Install the fuel tank to filler pipe hose to the fuel sub tank sub-assembly, and tighten the clamp to secure the hose.


Hide 77010 3.INSTALL FUEL TANK VENT TUBE ASSEMBLY

a.

Install a new gasket and the fuel tank vent tube assembly with the 8 screws.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Attach the wire harness clamp.


Hide 77100Z 4.INSTALL FUEL SUB TANK SUB-ASSEMBLY

a.

Set the fuel sub tank sub-assembly on a transmission jack and lift up the transmission jack.


b.

Connect the 2 fuel tank bands with the 4 bolts.

Torque:
40 N*m (408 kgf*cm, 30 ft.*lbf)


c.

Connect the fuel sender gauge connector.


Hide 77269A 5.CONNECT FUEL TANK BREATHER HOSE

a.

Connect the fuel tank breather hose to the filler pipe, and tighten the clamp to secure the hose.


Hide 77213B 6.CONNECT FUEL TANK TO FILLER PIPE HOSE

a.

Connect the fuel tank to filler pipe hose to the filler pipe, and tighten the clamp to secure the hose.


Hide 7.CONNECT FUEL HOSE

a.

Connect the fuel evaporation hose, fuel breather hose and 3 fuel hoses to the fuel tank vent tube assembly, and slide the 5 clamps to secure the hoses.


Hide 77606C 8.INSTALL NO. 2 FUEL TANK PROTECTOR

a.

Install the No. 2 fuel tank protector with the 5 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART