Home › Engine / Hybrid System › 2TR-FE (FUEL) › FUEL PRESSURE PULSATION DAMPER › from 2020.08
RM27T0E _51 Engine / Hybrid System _053666 2TR-FE FUEL _0260532 FUEL PRESSURE PULSATION DAMPER A

2TR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pressure pulsation damper assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 23270 5.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

A355184

a.

Remove the 2 bolts and fuel pressure pulsation damper assembly.


b.
A223395E05
0.428,0.699 0.629,0.886 0.201,0.187 10 *a 0.655,0.789 0.9,0.789 0.9,0.789 1.858,1.163 false

Remove the O-ring from the fuel pressure pulsation damper assembly

Text in Illustration
*a O-ring