The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel filter assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
23271F
4.DISCONNECT FUEL HOSE
Disconnect the hose from the clamp.
Disconnect the fuel hose (See page Engine / Hybrid System>2TR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
77251B
5.DISCONNECT FUEL MAIN TUBE
Disconnect the fuel main tube (See page Engine / Hybrid System>2TR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
23300
6.REMOVE FUEL FILTER ASSEMBLY
Remove the 3 bolts and fuel filter assembly.
23300
7.INSTALL FUEL FILTER ASSEMBLY
Install the fuel filter assembly with the 3 bolts.
77251B
8.CONNECT FUEL MAIN TUBE
Connect the fuel main tube (See page Engine / Hybrid System>2TR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
23271F
9.CONNECT FUEL HOSE
Connect the fuel hose (See page Engine / Hybrid System>2TR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
Connect the hose to the clamp.
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
12.INSPECT FOR FUEL LEAK