77651A
1.INSTALL NO. 1 FUEL TANK CUSHION
Install new 2 No. 1 fuel tank cushions to the fuel tank sub-assembly.
77295C
2.INSTALL FUEL TUBE GROMMET
Attach the clamp to install the fuel tube grommet.
77011
3.INSTALL FUEL TANK FILLER PIPE LOWER SUB-ASSEMBLY
Install a new gasket and the fuel tank filler pipe lower sub-assembly with the 8 screws.
77269A
4.INSTALL FUEL TANK BREATHER HOSE
Install the fuel tank breather hose to the fuel tank sub-assembly.
77213B
5.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose to the fuel tank sub-assembly.
83320
6.INSTALL FUEL SENDER GAUGE ASSEMBLY
Install a new gasket and the fuel sender gauge assembly with the 5 screws.
Be careful not to bend the arm of the fuel sender gauge assembly.
77380
7.INSTALL FUEL CUT OFF VALVE ASSEMBLY
Install the fuel cut off valve assembly to the fuel tank sub-assembly.
77026B
8.INSTALL NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Install a new gasket and the No. 1 fuel evaporation tube sub-assembly with the 4 screws and attach the clamp.
77240
9.INSTALL FUEL SUCTION TUBE ASSEMBLY
77100U
10.INSTALL FUEL TANK SUB-ASSEMBLY
Set the fuel tank sub-assembly on an engine lifter and lift up the engine lifter.
Install the 2 fuel tank band sub-assemblies with the 2 pins and 2 clips.
Connect the 2 fuel tank band sub-assemblies with the 2 bolts.
77269A
11.CONNECT FUEL TANK BREATHER HOSE
Connect the fuel tank breather hose to the filler pipe.
77213B
12.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose to the filler pipe.
13.CONNECT FUEL HOSE
Connect the fuel evaporation hose and fuel hose.
77251B
14.CONNECT FUEL MAIN TUBE
Connect the fuel main tube (See page Engine / Hybrid System>2TR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
77606
15.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Install the No. 1 fuel tank protector sub-assembly with the 5 bolts.
58325E
16.INSTALL REAR FLOOR SERVICE HOLE COVER
Connect the fuel sender gauge connector and fuel pump connector.
Install the rear floor service hole cover with the 3 screws.
58574A
17.INSTALL REAR FLOOR MAT SUPPORT PLATE
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
20.INSPECT FOR FUEL LEAK