Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) › from 2020.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261055 ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System) L

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

When disconnecting and reconnecting the battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





PRECAUTIONS WHEN USING GTS


a.

When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.



PRECAUTION FOR REGISTRATION


a.

If replacing any of the following parts, refer to Service Bulletin.

i.

Certification ECU (smart key ECU assembly)


ii.

ID code box (immobiliser code ECU)


iii.

Steering lock ECU (steering lock actuator or upper bracket assembly)


iv.

Electrical key transmitter sub-assembly


v.

ECM


vi.

Main body ECU (multiplex network body ECU)




PRECAUTIONS FOR BATTERY


a.

Immediately after disconnecting and reconnecting the battery cable, the entry unlock function may not operate. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock or mechanical key operation.


b.

When the battery is discharged, if the 12 V battery of another vehicle is used to jump start the engine, move the shift lever to P and open and close the driver door with the engine switch off before starting the engine.


c.

After the battery is removed and reinstalled, be sure to wait 10 seconds or more before the next engine start. The engine may not start immediately after the battery is reinstalled.

HINT:
·

After disconnecting and reconnecting the battery cable, the engine may not start on the first attempt. If this occurs, turn the engine switch off. The engine will start normally from the second time onward.

·

When the battery cable is disconnected and reconnected, the power source mode returns to the mode it was in before the battery cable was disconnected.





DOOR CONTROL RECEIVER EXPRESSIONS


a.

The type of door control receiver used on this model differs depending on the specifications of the vehicles. The expressions listed in the table below are used in this section.

Vehicle Specification Part Name in Manual Actual Part Name
for 12 Pin Type Door control receiver Electrical key & TPMS receiver assembly
except 12 Pin Type Door control receiver Smart door control receiver assembly