This circuit provides power to operate the parking assist ECU.
When "!" mark is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
(See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION)
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I6-4 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: w/o Stop and Start System *2: w/ Stop and Start System |
||
| I6-1 (+B) - Body ground | Always | 11 to 14 V*1
10.5 to 16 V*2 |
| I6-8 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V*1
10.5 to 16 V*2 |
| Engine switch off | Below 1 V | |
| I6-9 (ACC) - Body ground | Engine switch on (ACC) | 11 to 14 V*1
10.5 to 16 V*2 |
| Engine switch off | Below 1 V | |
| *a | Rear view of wire harness connector
(to Parking Assist ECU) |
OK
NG