Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261011 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A46  Yaw Rate Sensor  


DESCRIPTION

The blind spot monitor sensor receives yaw rate signals from the yaw rate and acceleration sensor via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C1A46 A fail flag is transmitted from the yaw rate and acceleration sensor
·

Vehicle stability control system

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.


PROCEDURE

1.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for vehicle stability control system DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).

OK:

Vehicle stability control system DTCs are not output.




OK

2.CHECK FOR DTC

NG

2.CHECK FOR DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTCs are output. A
DTC C1A46 is output ("Blind Spot Monitor Master"). B
DTC C1A46 is output ("Blind Spot Monitor Slave"). C



A

B

C