The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the starter assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51450
3.REMOVE REAR ENGINE UNDER COVER ASSEMBLY
31470
4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
28100
5.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Remove the terminal cap.
Remove the nut and disconnect the starter wire.
for Automatic Transmission:
Remove the 2 bolts and starter assembly.
for Manual Transmission:
Remove the bolt and disconnect the clutch flexible hose bracket.
| *1 | Clutch Flexible Hose Bracket |
Remove the bolt and starter assembly.