1.INSTALL BRAKE ACTUATOR BOLT CUSHION
Install the 3 brake actuator bolt cushions to the brake actuator bracket.
2.INSTALL BRAKE ACTUATOR CASE COLLAR
Install the 3 brake actuator case collars to the brake actuator bolt cushions.
Make sure the collars are in full contact with the cushions.
3.INSTALL BRAKE ACTUATOR BRACKET
Install the brake actuator bracket to the brake actuator with the 3 bolts. Tighten the 3 bolts uniformly in alphabetical order.
Do not remove the hole plugs of a new brake actuator before connecting the 6 brake lines because the brake actuator is filled with brake fluid.
Do not hold the actuator by the connector.
If the actuator is dropped, replace it.
4.INSTALL BRAKE ACTUATOR ASSEMBLY
Install the brake actuator with bracket with the 3 nuts. Tighten the 3 nuts uniformly in alphabetical order.
Do not damage the brake lines or wire harness.
Do not hold the actuator by the connector.
If the actuator is dropped, replace it.
Set each brake line in the correct position on the brake actuator as shown in the illustration.
*1: To front wheel cylinder RH
*2: To front wheel cylinder LH
*3: To rear wheel cylinder RH
*4: To rear wheel cylinder LH
*5: From front master cylinder
*6: From rear master cylinder
Using a union nut wrench, tighten each brake line.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the brake actuator connector.
Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
5.INSTALL AIR CLEANER CASE SUB-ASSEMBLY (for 2TR-FE)
6.INSTALL AIR CLEANER CASE ASSEMBLY (for 5L-E)
7.BLEED BRAKE SYSTEM
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9.INSPECT BRAKE ACTUATOR WITH INTELLIGENT TESTER
10. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART