Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.REMOVE REAR WHEEL LH
76608
4.REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH
48978
5.REMOVE HEIGHT CONTROL COMPRESSOR COVER
Remove the 3 clips and height control compressor cover.
52046A
6.REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)
48925
7.REMOVE HEIGHT CONTROL FILTER
Slide the 2 clips and disconnect the 2 hoses.
Remove the 2 bolts and height control filter from the height control compressor bracket.
48982
8.DISCONNECT NO. 2 HEIGHT CONTROL TUBE
Disconnect the No. 2 height control tube from the No. 2 height control valve (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).
For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.
48910B
9.REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY
Disconnect the connector.
Detach the 3 clamps.
Detach the No. 2 height control tube.
Disconnect the connector.
Detach the clamp.
Remove the 3 bolts and height control compressor.
Remove the bolt and height control dryer.
Remove the O-ring.
Remove the 3 bushes from the height control compressor.
48911
10.REMOVE HEIGHT CONTROL COMPRESSOR BRACKET
Remove the 3 bolts and height control compressor bracket.