Home › Suspension › SUSPENSION CONTROL › CONTROL VALVE ASSEMBLY › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260875 CONTROL VALVE ASSEMBLY A

SUSPENSION CONTROL  CONTROL VALVE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.

·

Check the safety of your surroundings and use caution when disconnecting each height control valve air tube as the air in each pneumatic cylinder will be discharged and the vehicle body will lower.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.DISCONNECT HEIGHT CONTROL TUBE

a.
C216421

Disconnect the connector.


b.

Disconnect the 3 height control tubes (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

HINT:

For the disconnection procedure of the tubes (type 1 and type 2), refer to Precaution of the Suspension Control System section.



Hide 48960 4.REMOVE NO. 2 HEIGHT CONTROL VALVE SUB-ASSEMBLY

a.
C216422

Remove the 2 bolts and No. 2 height control valve.