Home › Suspension › SUSPENSION CONTROL › STABILIZER CONTROL VALVE(w/ KDSS) › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260872 STABILIZER CONTROL VALVE(w/ KDSS) A

SUSPENSION CONTROL  STABILIZER CONTROL VALVE(w/ KDSS)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 48826D 4.REMOVE STABILIZER CONTROL VALVE PROTECTOR

a.
C212853

Remove the 2 bolts and stabilizer control valve protector.


Hide 5.DRAIN SUSPENSION FLUID

a.
C212854

Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

HINT:
·

Drain suspension fluid when performing operations related to the hydraulic circuits.

·

Draining suspension fluid decreases suspension fluid pressure.




b.

Tighten the bleeder plug.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


Hide 48890 6.DISCONNECT FRONT NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.
C301673

Using a union nut wrench, disconnect the 2 flare nuts from the stabilizer control with accumulator housing to disconnect the front No. 1 stabilizer control tube assembly.


Hide 44327N 7.DISCONNECT REAR NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.
C301799

Using a union nut wrench, disconnect the 2 flare nuts from the stabilizer control with accumulator housing.


b.

Remove the 2 bolts and disconnect the rear No. 1 stabilizer control tube assembly.


Hide 48860D 8.REMOVE STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

a.
C214833

Disconnect the connector, and then detach the clamp from the sensor bracket.


b.

Remove the 3 bolts and stabilizer control with accumulator housing.

NOTICE:

Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.