Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.REMOVE REAR WHEEL
89408D
4.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Disconnect the connector, and then detach the connector.
Detach the clamp.
Place matchmarks on the link and bracket.
| *1 | Matchmark |
Remove the nut and disconnect the sensor link.
Remove the 2 bolts and height control sensor.
Replace the rear height control sensor sub-assembly with a new one if it is dropped.
5.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
Use the same procedure described for the LH side.