Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260881 ABSORBER CONTROL ACTUATOR A

SUSPENSION CONTROL  ABSORBER CONTROL ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.REMOVE FRONT WHEEL

Hide 89241B 4.REMOVE ABSORBER CONTROL ACTUATOR LH

a.
C213631

Detach the 3 clamps, and then disconnect the connector.


b.

Using a hexagon wrench (4 mm), remove the 2 hexagon socket head cap bolts and absorber control actuator.

NOTICE:

Replace the absorber control actuator with a new one if it is dropped.



Hide 89269A 5.REMOVE SUSPENSION CONTROL BRACKET LH

a.
C115604E01
2.697,1.012 3.131,1.217 0.434,0.205 10 SST 2.697,1.081 2.499,1.081 false 2.499,1.081 2.242,1.778 false

Using SST, remove the nut and bracket.

SST
09961-00950