Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
71970
1.REMOVE REAR SEAT HEADREST ASSEMBLY
Remove the headrest.
73949
2.REMOVE CAP
Remove the 2 caps.
71693
3.REMOVE REAR SEAT LOWER CUSHION HINGE COVER LH
Remove the 2 screws.
Detach the 3 claws and remove the cover.
71693
4.REMOVE REAR SEAT LOWER CUSHION HINGE COVER RH
| *a | Guide |
Remove the 2 screws.
Detach the 2 claws and guide and remove the cover.
71827B
5.REMOVE REAR NO. 1 SEAT CUSHION MOULDING
| *a | Guide |
Using a clip remover, remove the 2 clips.
Detach the 2 claws and 4 guides and remove the moulding.
6.REMOVE SEAT CUSHION COVER WITH PAD
| *a | Fastener |
Open the 2 fasteners.
Using a clip remover, remove the 2 clips and open the under part of the seat cushion cover.
| *a | Hook |
Detach the 2 hooks and remove the seat cushion cover with pad.
79032
7.REMOVE NO. 3 SEAT CUSHION COVER SUB-ASSEMBLY LH
| *a | Fastener |
Detach the fastener.
Remove the hog rings and seat cushion cover.
71647F
8.REMOVE REAR SEAT CUSHION INNER EDGE PROTECTOR LH
| *a | Tack Pin |
Cut off the tack pins and remove the edge protector from the seat cushion pad.
71827B
9.REMOVE REAR NO. 2 SEAT CUSHION MOULDING
Remove the 2 screws.
Detach the 2 claws and remove the moulding.
79202
10.REMOVE NO. 2 SEAT CUSHION FRAME SUB-ASSEMBLY LH
Operate the rear No. 2 seat lock control lever and retract the seat cushion frame.
Using a T40 "TORX" socket wrench, remove the 4 "TORX" bolts and remove the seat cushion frame.
72906
11.REMOVE 3RD SEAT LINK SUB-ASSEMBLY LH
| *a | Guide |
Remove the 3 clips.
Detach the 2 claws and 4 guides and remove the 3rd seat link.
72058B
12.REMOVE REAR NO. 2 SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
| *a | Cable End |
| *b | Clamp |
Detach the clamp.
Twist the cable end in the direction indicated by the arrow and disconnect the cable.
| *a | Guide |
Remove the screw.
Detach the 2 guides and remove the lever.
79384
13.REMOVE REAR SEAT LEG COVER LH
| *a | Hook |
Remove the clip.
Detach the 3 hooks and 5 clips and remove the cover.
79384A
14.REMOVE REAR NO. 3 SEAT LEG COVER LH
Detach the 2 claws and remove the cover.
73590
15.REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH
71694E
16.REMOVE REAR SEAT CUSHION INNER HINGE COVER LH
| *a | Guide |
Remove the screw and clip.
Detach the guide and remove the cover.
71694E
17.REMOVE REAR SEAT CUSHION INNER HINGE COVER RH
| *a | Guide |
Remove the screw and clip.
Detach the guide and remove the cover.
72695C
18.REMOVE REAR SEAT LOCK CONTROL CABLE LH
| *a | Clamp |
| *b | Cable End |
Detach the clamp.
Twist the cable end in the direction indicated by the arrow and remove the cable.
72615H
19.REMOVE REAR NO. 1 SEATBACK LOCK STRIKER COVER
| *a | Guide |
| *b | Protective Tape |
Using a screwdriver, detach the claw and guide and remove the cover.
Tape the screwdriver tip before use.
72058B
20.REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
| *a | Clamp |
| *b | Cable End |
| *c | Guide |
Remove the 2 screws.
Detach the guide and remove the lever.
Detach the clamp.
Twist the cable end in the direction indicated by the arrow and disconnect the cable.
66310F
21.REMOVE ROPE HOOK ASSEMBLY
| *a | Protective Tape |
Using a screwdriver, detach the 2 claws and open the cover.
Tape the screwdriver tip before use.
Remove the bolt and rope hook.
72615G
22.REMOVE REAR NO. 2 SEATBACK LOCK STRIKER COVER
| *a | Guide |
| *b | Protective Tape |
Using a screwdriver, detach the claw and guide and remove the cover.
Tape the screwdriver tip before use.
72690A
23.REMOVE REAR SEAT LOCK RELEASE LEVER ASSEMBLY
| *a | Hook |
Remove the 2 screws.
Detach the hook and remove the lever.
| *a | Cable End |
| *b | Clamp |
Detach the 2 clamps.
Twist the 2 cable ends in the direction indicated by the arrow and disconnect the 2 cables.
71702C
24.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
Detach the 7 clips and remove the board.
71931C
25.REMOVE REAR NO. 2 SEAT HEADREST SUPPORT ASSEMBLY
Detach the 4 claws and remove the 2 headrest supports.
26.REMOVE SEATBACK COVER WITH PAD
| *a | Hook |
Detach the hooks and remove the seatback cover with pad.
79034
27.REMOVE REAR NO. 3 SEATBACK COVER SUB-ASSEMBLY LH
Remove the hog rings and seatback cover.
71587C
28.REMOVE REAR NO. 2 SEATBACK EDGE PROTECTOR
| *a | Tack Pin |
Cut off the tack pins and remove the protector from the seatback pad.
79962
29.REMOVE NO. 2 SEATBACK COVER
Detach the 2 claws and remove the cover.
71834C
30.REMOVE REAR NO. 3 SEAT INNER RECLINING COVER LH
Detach the 4 claws and remove the cover.
71834C
31.REMOVE REAR NO. 3 SEAT OUTER RECLINING COVER LH
| *a | Guide |
Remove the screw.
Detach the guide and 2 claws and remove the cover.
71844C
32.REMOVE REAR NO. 2 SEAT INNER RECLINING COVER LH
Detach the 5 claws and remove the cover.
71844A
33.REMOVE REAR NO. 2 SEAT OUTER RECLINING COVER LH
| *a | Guide |
Remove the screw.
Detach the guide and 2 claws and remove the cover.
78091
34.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
| *a | Clamp A |
| *b | Clamp B |
| *c | Cable Tie |
| *d | Cable End |
Remove the clamp labeled B and detach the 2 labeled clamps A.
Cut off the 2 cable ties.
Twist the cable end in the direction indicated by the arrow and remove the cable.
79226
35.REMOVE NO. 2 SEAT LOCK CABLE
| *a | Clamp |
| *b | Cable End |
Detach the clamp.
Twist the cable end in the direction indicated by the arrow and remove the cable.
79304A
36.REMOVE NO. 3 SEATBACK FRAME SUB-ASSEMBLY LH
Using a T45 "TORX" socket wrench, remove the 4 "TORX" bolts and frame.
82824
37.REMOVE WIRING HARNESS CONNECTOR (w/ Seat Belt Warning System)
Remove the warning reflector holder.
Detach the claw and remove the wiring harness connector.
82196
38.REMOVE REAR NO.2 SEAT WIRE LH (w/ Seat Belt Warning System)
Detach the wire harness clamp and remove the rear No. 2 seat wire LH.
79040
39.REMOVE NO. 3 SEAT LEG ASSEMBLY LH
Remove the 4 clips and seat cushion under carpet LH from the No. 3 seat leg.
79020B
40.REMOVE NO. 2 SEAT LEG ASSEMBLY (for RH Side)
Remove the 4 clips and seat cushion under carpet RH from the No. 2 seat leg.