Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › from 2021.06
RM27T0E _56 Audio / Visual / Telematics _056796 TELEMATICS _0277431 TELEMATICS SYSTEM C

TELEMATICS  TELEMATICS SYSTEM  B15C511  Emergency Call Switch Circuit Short to Ground  B15C513  Emergency Call Switch Circuit Open  


DESCRIPTION

If the telephone transceiver assembly detects an error in the communication between the telephone transceiver assembly and the map light assembly (manual [SOS] switch) as a result of the telephone transceiver assembly self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C511 Emergency Call Switch Circuit Short to Ground Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Telephone transceiver assembly

·

Map light assembly (manual [SOS] switch)

·

Harness or connector


B15C513 Emergency Call Switch Circuit Open Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Telephone transceiver assembly

·

Map light assembly (manual [SOS] switch)

·

Harness or connector



WIRING DIAGRAM

E364512E85
0.375,3.167 2.865,3.354 2.49,0.188 10 false Telephone Transceiver Assembly 0.396,2.99 1.406,3.354 1.01,0.365 10 false G333 3.729,3.01 3.979,3.25 0.25,0.24 10 false W7 3.729,3.177 5.958,3.448 2.229,0.271 10 false Map Light Assembly 1.292,0.99 1.688,1.146 0.396,0.156 10 false SIG1 1.698,0.99 1.875,1.167 0.177,0.177 10 false 21 3.677,0.979 4.073,1.135 0.396,0.156 10 false SIG1 3.375,0.979 3.615,1.135 0.24,0.156 10 false 20 4.156,1.552 5.875,1.844 1.719,0.292 10 false Manual (SOS) Switch 3.677,2.302 4.073,2.458 0.396,0.156 10 false GND3 3.417,2.302 3.615,2.469 0.198,0.167 10 false 3 1.313,2.313 1.625,2.469 0.313,0.156 10 false SIG- 1.729,2.302 1.906,2.479 0.177,0.177 10 false 3

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
a.
E140936C41
1.906,0.406 2.073,0.406 2.073,0.406 2.354,1.365 true 1.948,1.615 2.063,1.99 2.063,1.99 2.24,1.99 true 2.271,1.917 2.885,2.115 0.615,0.198 10 false SIG1 1.5,0.333 2.115,0.531 0.615,0.198 10 false GND3 0.135,0.115 0.75,0.313 0.615,0.198 10 false *a
*a Component without harness connected
(Map Light Assembly [Manual (SOS) Switch])


Remove the map light assembly.

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT (for Front Door)>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
20 (SIG1) - 3 (GND3) Manual (SOS) switch not pressed 410 to 414 Ω
20 (SIG1) - 3 (GND3) Manual (SOS) switch pressed 81 to 83 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
a.

Disconnect the G333 telephone transceiver assembly connector.


b.

Disconnect the W7 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G333-21 (SIG1) - W7-20 (SIG1) Always Below 1 Ω
G333-3 (SIG-) - W7-3 (GND3) Always Below 1 Ω
G333-21 (SIG1) - Body ground Always 10 kΩ or higher
G333-3 (SIG-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT