Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › from 2021.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260461 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P202A12  Reductant Tank Heater Control Circuit High Circuit Short to Battery  P202A14  Reductant Tank Heater Control Circuit Low Circuit Short to Ground or Open  


DESCRIPTION

An electric heater is provided inside the urea tank and urea pipe, as urea solution freezes at -11°C (12.2°F) or lower.

The heater thaws frozen urea solution and prevents further freezing, allowing the urea SCR system to be started even in cold environments.

The tank heater turns ON and OFF according to the value of the temperature sensor. The heater for the urea tube with heater assembly turns ON and OFF according to the value of the ambient temperature sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P202A12 Reductant Tank Heater Control Circuit High Circuit Short to Battery When the tank heater (urea pump assembly) is operating, an open or short circuit occurs in the tank heater for 1 second or more.
(1 trip detection logic)
Urea pump assembly (urea pump control ECU integrated urea pump) Comes on DTC stored SAE Code: P202C
P202A14 Reductant Tank Heater Control Circuit Low Circuit Short to Ground or Open When the tank heater (urea pump assembly) is operating, an open or short circuit occurs in the tank heater for 1 second or more.
(1 trip detection logic)
Urea pump assembly (urea pump control ECU integrated urea pump) Comes on DTC stored SAE Code: P202B

Related Data List
DTC No. Data List
P202A12
P202A14
Reductant Tank Heater

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P202A12
P202A14
Reductant Tank Heater (Active Test)

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.REPLACE UREA PUMP ASSEMBLY (UREA PUMP CONTROL ECU INTEGRATED UREA PUMP)
a.

Replace the urea pump assembly (urea pump control ECU integrated urea pump).

Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Clear the DTCs.


d.

Turn the engine switch off for 30 seconds or more.


e.

Turn the engine switch on (IG) and turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.


g.

Perform the Active Test.


h.

Enter the following menus: Powertrain / Engine / Trouble Codes.


i.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END