DISASSEMBLY
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. REMOVE STARTER YOKE ASSEMBLY |
Remove the nut and disconnect the lead wire from terminal C.

Remove the 2 bolts.
Pull out the starter yoke and starter commutator end frame together with the starter armature.
Remove the O-ring from the starter yoke.
| 2. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
Remove the 2 screws and magnet starter switch.

Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.


Using a magnet hand, remove the steel ball from the starter clutch hole.

| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
Remove the 2 screws and commutator end frame from the starter yoke.

- NOTICE:
- While holding down the lead wire, remove the starter commutator end frame.
Remove the dust protector from the commutator end frame.
Remove the O-ring from the starter yoke.
Disconnect the 4 brushes from the starter brush holder.

Using a screwdriver, hold back the spring.
Disconnect the brush from the brush holder.
Remove the brush holder.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
Remove the starter armature from the starter yoke.
