2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE STARTER YOKE ASSEMBLY

  1. A219637
    Remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 bolts.

  1. Pull out the starter yoke and commutator end frame together with the starter armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A219638
    Remove the 2 bolts and magnet starter switch.

  1. A219639E01
    Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.
    Text in Illustration 
    *1
    Starter Drive Housing
    *2
    Starter Clutch
    *3
    Return Spring
    *4
    Idle Gear
    *5
    Retainer
    *6
    Clutch Roller

  1. A115020E03
    Using a magnet hand, remove the steel ball from the starter clutch hole.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A219640
    Remove the 2 screws, and then remove the commutator end frame from the starter yoke.

    NOTICE:
    While holding down the lead wire, remove the commutator end frame.

  1. Remove the O-ring from the starter yoke.

  1. A215926
    Disconnect the 4 brushes from the starter brush holder.

    1. Using a screwdriver, hold back the brush spring.

    2. Disconnect the brush from the starter brush holder.

  1. Remove the starter brush holder.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← DISASSEMBLY (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →