2011-2013 Land Cruiser · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL CLUTCH DISC ASSEMBLY

C173323E01
  1. Insert SST into the clutch disc, then insert the clutch disc into the flywheel.

    SST
    09301-00120  

    NOTICE:
    Take care not to insert the clutch disc in the wrong direction.


2. INSTALL CLUTCH COVER ASSEMBLY

C173324E01
  1. Align the matchmark on the clutch cover with the one on the flywheel.

  1. In the order shown in the illustration, temporarily install the 8 bolts starting from the bolt located near the knock pin on the top.

  1. Check that the disc is in the center by lightly moving SST up and down, and left and right.

    SST
    09301-00120  

  1. Evenly tighten the bolts by following the order shown in the illustration.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C173325
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum Misalignment:
    1.3 mm (0.0512 in.)

  1. C173326E01
    If the alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
    SST
    09333-00013  


4. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

C163041E01
  1. Apply release hub grease to the release fork, release bearing, push rod contact point and pivot points shown in the illustration.

    Grease:
    Toyota Genuine Release Hub Grease or equivalent

  1. C173314E01
    Apply clutch spline grease to the input shaft spline.

    Grease:
    Toyota Genuine Clutch Spline Grease or equivalent

  1. C163036
    Install the release bearing to the clutch release fork with the clip.

  1. C173316
    Install the release fork support to the transmission unit.

    Torque:
    47 N*m{ 480 kgf*cm , 35 ft.*lbf }

  1. Install the clutch release fork with the clutch release bearing to the transmission unit.

    HINT:
    After installation, move the fork back and forth to check that the release bearing slides smoothly.


5. INSTALL MANUAL TRANSMISSION ASSEMBLY
  1. Install the manual transmission (Click here).

← INSPECTION (from Sep 2011)COMPONENTS (from Sep 2011) →