2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

FAIL-SAFE CHART

System information · Vehicles built Sep 2011 – Dec 2011

If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
DTC
Component
Fail-Safe Operation
Fail-Safe Deactivation Condition
P0031, P0032, P0051 and P0052
Air-Fuel Ratio (A/F) Sensor Heater
The ECM turns off the A/F sensor heater.
Engine switch off
P0037, P0038, P0057 and P0058
Heated Oxygen (HO2) Sensor Heater
The ECM turns off the HO2 sensor heater.
Engine switch off
P0102 and P0103
Mass Air Flow (MAF) Meter
The ECM calculates the ignition timing according to the engine speed and throttle valve position.
Pass condition detected
P0110, P0112 and P0113
Intake Air Temperature (IAT) Sensor
The ECM estimates the IAT to be 20°C (68°F).
Pass condition detected
P0115, P0117 and P0118
Engine Coolant Temperature (ECT) Sensor
The ECM estimates the ECT to be 80°C (176°F).
Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Electronic Throttle Control System (ETCS)
The ECM cuts off the throttle actuator current and the throttle valve is returned to 7° throttle position by the return spring.
The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle to allow the vehicle to continue at minimal speed.*
Pass condition detected and then engine switch turned off
P0327, P0328, P0332 and P0333
Knock Sensor
The ECM sets the ignition timing to maximum retard.
Engine switch off
P0351 to P0358
Igniter
The ECM cuts fuel.
Pass condition detected
P0504
Stop Light Switch
The accelerator pedal angle is fixed.
Pass condition detected and then engine switch turned off
P2440 and P1441 and/or P1444
Secondary Air Injection system
The throttle is restricted (ex. 70 km/h or less).
Pass condition detected
P1441 and P1444
Secondary Air Injection system
The throttle is restricted (ex. 100 km/h or less).
Pass condition detected
P1441 or P1444
Secondary Air Injection system
The throttle is restricted (no problem under normal driving).
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator Pedal Position (APP) Sensor
The APP sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, the ECM controls the engine using the other circuit.
If both circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve is closed and the engine idles.
Pass condition detected and then engine switch turned off
P2431
Secondary Air Injection System
The throttle is restricted (ex. 100 km/h or less).
Pass condition detected

HINT:
*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.

← CHECK MODE PROCEDURE (Sep 2011 – Dec 2011)DATA LIST / ACTIVE TEST (Sep 2011 – Dec 2011) →