2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
    NEXT

    3.BASIC INSPECTION
    1. Turn the engine switch on (IG).

    2. Check whether or not the radio receiver assembly turns on.

      Result 
      Result
      Proceed to
      Radio receiver assembly turns on
      A
      Radio receiver assembly does not turn on
      B


    B.
    A

    4.CHECK FOR DTC

      HINT:
      Refer to DTC Check/Clear (Click here).

    1. Check for DTCs and note any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs by simulating the operation indicated by the DTCs.

      HINT:
      1. If the system cannot enter diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the malfunctioning part.
      2. Even if the symptom malfunction is not confirmed, check the DTCs. This is because the system stores history DTCs.
      3. Check and clear history DTCs. Then recheck for DTCs.
        Result 
        Result
        Proceed to
        DTC is output again
        A
        DTC is not output
        B


    B.
    A

    5.DIAGNOSTIC TROUBLE CODE CHART

      HINT:
      Refer to Diagnostic Trouble Code Chart (Click here).


    NEXT.
    6.PROBLEM SYMPTOMS TABLE

      HINT:
      Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B

    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING

      HINT:
      Refer to Terminals of ECU (Click here).

    NEXT

    8.ADJUST, REPAIR OR REPLACE
      NEXT

      9.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)IDENTIFICATION OF NOISE SOURCE (from Sep 2011) →