2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Voice Recognition Difficulty

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK CONDITION
  1. Check if the system voice recognition level is low when recognizing a particular voice.

    Result 
    Result
    Proceed to
    System voice recognition level is low with any voice.
    A
    System voice recognition level is low only for a particular voice.
    B

    HINT:
    System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.



B
END
A


2. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


3. CHECK MAP DISC

  1. I100201E04
    Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.

    HINT:
    If dirt on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.



NG
CLEAN MAP DISC
OK


4. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
CABIN TO APPROPRIATE TEMPERATURE
OK


5. CHECK MICROPHONE (OPERATION CHECK)

  1. E176524E01
    Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END


← Route cannot be Calculated (Sep 2011 – Dec 2011)Voice is not Recognized (Sep 2011 – Dec 2011) →