Voice is not Recognized
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
INSPECTION PROCEDURE
| 1. CHECK NAVIGATION SETTING |
 |
Display the "Voice Settings" screen.
- Check that "Voice Recognition Guidance" is not "Off".
- OK:
- "Voice Recognition Guidance" is not "Off".
|
NG |
 |
|
| TURN VOICE RECOGNITION GUIDANCE "On" |
|
|
| OK |
|
 |
|
| 2. CHECK MAP DISC |
 |
- Check that the map disc is not deformed or cracked.
- OK:
- No deformations or cracks on the map disc
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK MAP DISC |
 |
- Check for dirt on the map disc surface.
- OK:
- No dirt is on the map disc surface.
- NOTICE:
- Do not use a conventional record cleaner or anti-static preservative.
- HINT:
- If dirt on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK CABIN |
 |
Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
- HINT:
- A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
- The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.
- OK:
- Condensation is not likely being produced and the temperature is not high or extremely low.
|
NG |
 |
|
| SET CABIN TO APPROPRIATE TEMPERATURE |
|
|
| OK |
|
 |
|
| 5. CHECK MICROPHONE (OPERATION CHECK) |
 |
- Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
| REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
|
|