2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Vehicle Position Mark is not Updated

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


2. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK


3. CHECK VEHICLE SENSOR (OPERATION CHECK)

  1. E176549
    Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cursor or Map Rotates when Vehicle Stopped (Sep 2011 – Dec 2011)Current Position Display does not Appear (Sep 2011 – Dec 2011) →