2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Current Position Display does not Appear

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK NAVIGATION MODULE BOARD
  1. Display the "Map DVD" screen.

  1. E176548E06
    Check if a disc is inserted into the map disc slot.
    1. Check if the map data version is displayed in the "Map Data" section.

      Result 
      Result
      Proceed to
      The map data version is displayed.
      A
      The map data version is not displayed.
      B



B
INSERT MAP DISC IN MAP DISC SLOT
A


2. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


3. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
CABIN TO APPROPRIATE TEMPERATURE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Position Mark is not Updated (Sep 2011 – Dec 2011)GPS Mark is not Displayed (Sep 2011 – Dec 2011) →