Cellular Phone cannot Make Outgoing/Incoming Calls
Circuit diagnosis · Vehicles built from Jan 2012
INSPECTION PROCEDURE
| 1. CHECK "Bluetooth" SETTINGS |
Check if the cellular phone is registered as a connected device and the "Bluetooth" settings are correct.
- OK:
- The cellular phone is registered as a connected device and "Bluetooth" settings are correct.
|
|
||||
| OK | |
| 2. CHECK SETTINGS AND CONDITIONS |
Check the cellular phone functions.
- HINT:
- The cellular phone is unable to call under any of the following conditions:
- The cellular phone is locked.
- The phonebook is being transferred.
- The line is crossed.
- The cellular phone is outside service range.
- The power is off.
- The battery is low.
- The cellular phone is not connected via "Bluetooth".
- The cellular phone is locked.
- OK:
- None of the above conditions exist.
|
|
||||
| OK | |
| 3. CHECK RECEPTION |
Place the cellular phone close to the multi-media module receiver assembly.
Set the cellular phone so that it can receive calls.
Check if the cellular phone has reception according to the multi-media module receiver assembly.
- OK:
- The cellular phone has reception.
|
|
||||
| OK | ||
| ||
| 4. CHECK CELLULAR PHONE |
Check if the cellular phone can make a call.
- HINT:
- The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.
- OK:
- Cellular phone can make a call.
|
|
||||
| OK | |
| 5. RESTART CELLULAR PHONE |
Restart the cellular phone.
Register the cellular phone as a connected device again and check that the malfunction disappears.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
| 6. CHECK CELLULAR PHONE |
Check if the cellular phone is "Bluetooth" compatible.
- HINT:
- Some versions of "Bluetooth" compatible cellular phones may not function.
- OK:
- The phone is "Bluetooth" compatible.
|
|
||||
| OK | ||
| ||
