2011-2013 Land Cruiser · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK FOR DTC*
    1. Check for DTCs and make a note of any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.

      Result 
      Result
      Proceed to
      No DTCs output
      A
      B2311 is output
      B
      B2312 is output
      B
      B2313 is output
      B
      LIN communication system DTCs are output
      C


    B.

    C.
    A

    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    6.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Door window regulator and power window regulator motor assembly is replaced or removed/installed.
      A
      Door window regulator and power window regulator motor assembly is not replaced or removed/installed.
      B

    B.
    A

    7.RESET POWER WINDOW REGULATOR MOTOR
    1. If a power window switch LED is blinking, initialize the power window regulator motor (Click here).

    NEXT

    8.CONFIRMATION TEST
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)OPERATION CHECK (from Sep 2011) →