2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

FAIL-SAFE CHART

System information · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition
Auto Cancel Condition
Fail-safe Deactivation Condition
CRUISE main indicator light blinks
  1. There is an open or short in the stop light switch circuit
  2. There is a problem with the vehicle speed signal
Turn the cruise control main switch on again
CRUISE main indicator light goes off
  1. There is a problem with the throttle position sensor and the motor*1
  2. There is a problem with the fuel injection system*2
Turn the cruise control main switch on again
CRUISE main indicator light blinks
  1. There is a problem with the input circuit of the stop light switch circuit
  2. There is a problem with the cancel circuit
  1. Turn the cruise control main switch on again
  2. Turn the ignition switch off then on again
CRUISE main indicator light remains on
(Cruise control is canceled)
Under the following conditions, the stored vehicle speed is maintained:
  1. The vehicle speed is less than the low speed limit (approx. 40 km/h (25 mph)) while running with the cruise control on
  2. The VSC system is operated
Push the cruise control main switch to +RES
  1. The vehicle speed is less than the stored speed by approx. 16 km/h (10 mph) or more
Push the cruise control main switch to -SET

HINT:
  1. *1: for 2UZ-FE, 1GR-FE, 3UR-FE
  2. *2: for 1VD-FTV

← DTC CHECK / CLEAR (from Sep 2011)FAIL-SAFE CHART (from Jan 2012) →