2011-2013 Land Cruiser · Service Manual Vehicle Interior

B278A Short to GND in Immobiliser System Power Source Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is output when the engine switch power source supply line is open or shorted.
DTC Code
DTC Detection Condition
Trouble Area
B278A
The engine switch power source supply line is open or shorted.
  1. Harness or connector
  1. Engine switch
  1. Certification ECU (Smart key ECU)

WIRING DIAGRAM

B153714E09

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)
B108731E18
  1. Disconnect the E29 ECU connector.

  1. Disconnect the E18 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-30 (VC5) - E18-14 (VC5)
    Always
    Below 1 Ω
    E29-40 (AGND) - E18-8 (AGND)
    E29-30 (VC5) or E18-14 (VC5) - Body ground
    Always
    10 kΩ or higher
    E29-40 (AGND) or E18-8 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. REPLACE ENGINE SWITCH
  1. for 1GR-FE

    1. Temporarily replace the engine switch with a new one (Click here).

  1. for 1UR-FE

    1. Temporarily replace the engine switch with a new one (Click here).

  1. for 1VD-FTV

    1. Temporarily replace the engine switch with a new one (Click here).

  1. for 3UR-FE

    1. Temporarily replace the engine switch with a new one (Click here).


NEXT


3. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


4. CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B278A is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ENGINE SWITCH IS DEFECTIVE)


← B278A Short to GND in Immobiliser System Power Source Circuit (Sep 2011 – Dec 2011)B2790 ID BOX EEPROM Malfunction (from Sep 2011) →