B278A Short to GND in Immobiliser System Power Source Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is output when the engine switch power source supply line is open or shorted.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B278A |
The engine switch power source supply line is open or shorted. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH) |


Disconnect the E29 ECU connector.
Disconnect the E18 switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E29-30 (VC5) - E18-14 (VC5)
Always
Below 1 Ω
E29-40 (AGND) - E18-8 (AGND)
E29-30 (VC5) or E18-14 (VC5) - Body ground
Always
10 kΩ or higher
E29-40 (AGND) or E18-8 (AGND) - Body ground
|
|
||||
| OK | |
| 2. REPLACE ENGINE SWITCH |
for 1GR-FE
Temporarily replace the engine switch with a new one (Click here).
for 2UZ-FE
Temporarily replace the engine switch with a new one (Click here).
for 1VD-FTV
Temporarily replace the engine switch with a new one (Click here).
for 3UR-FE
Temporarily replace the engine switch with a new one (Click here).
| NEXT | |
| 3. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 4. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B278A is not output.
|
|
||||
| OK | ||
| ||
