2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

  1. A225470E01
    Apply a light coat of spindle oil or gasoline to a new O-ring and install the O-ring to the fuel pressure pulsation damper.
    Text in Illustration 
    *1
    New O-Ring

  1. Install the fuel pressure pulsation damper to the fuel delivery pipe.

  1. Install the fuel pressure regulator holder.


2. INSTALL INTAKE AIR SURGE TANK
(Click here)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. INSPECT FOR FUEL LEAK
  1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

      NOTICE:
      Do not start the engine.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

    4. Check that there are no leaks from the fuel system.
      If there are fuel leaks, repair or replace parts as necessary.

    5. Turn the ignition switch off.

    6. Disconnect the GTS from the DLC3.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →