DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Sliding Roof / Data List.
According to the display on the intelligent tester, read the Data List.
Sliding Roof Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Open Switch
Sliding roof switch open signal/ON or OFF
ON: OPEN switch is pressed
OFF: OPEN switch is not pressed
-
Close Switch
Sliding roof switch close signal/ON or OFF
ON: CLOSE switch is pressed
OFF: CLOSE switch is not pressed
-
Up Switch
Sliding roof switch tilt up signal/ON or OFF
ON: UP switch is pressed
OFF: UP switch is not pressed
-
Down Switch
Sliding roof switch tilt down signal/ON or OFF
ON: DOWN switch is pressed
OFF: DOWN switch is not pressed
-
Hall IC1 Status
Sliding roof operation signal/Normal or Lock
Normal: Sliding roof motor is operating
Lock: Sliding roof motor is not operating
-
Hall IC1 Pulse
Sliding roof operation signal/Lo or Hi
Lo: Sliding roof motor is not operating
Hi: Sliding roof motor is operating
-
Hall IC2 Status
Sliding roof operation signal/Normal or Lock
Normal: Sliding roof motor is operating
Lock: Sliding roof motor is not operating
-
Hall IC2 Pulse
Sliding roof operation signal/Lo or Hi
Lo: Sliding roof motor is not operating
Hi: Sliding roof motor is operating
-
Door Courtesy
Driver door courtesy light switch signal/ON or OFF
ON: Driver door is open
OFF: Driver door is closed
-
Ignition (MPX)
Engine switch signal (MPX signal)/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Ignition (Direct Signal)
Engine switch signal/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Door Handle Lock Button
Entry lock switch/ON or OFF
ON: Entry lock switch is pressed
OFF: Entry lock switch is not pressed
-
Door Key Close Operation
Key-linked sliding roof close signal/ON or OFF
ON: Driver door key cylinder is turned to lock position using key
OFF: Driver door key cylinder is not turned
-
Door Key Open Operation
Key-linked sliding roof open signal/ON or OFF
ON: Driver door key cylinder is turned to unlock position using key
OFF: Driver door key cylinder is not turned
-
Wireless Open Operation
Wireless sliding roof open signal/ON or OFF
ON: Transmitter unlock switch is pressed
OFF: Transmitter unlock switch is not pressed
-
Wireless Close Operation
Wireless sliding roof close signal/ON or OFF
ON: Transmitter lock switch is pressed
OFF: Transmitter lock switch is not pressed
-
Key Off Permission
Key-off operation permit signal/ON or OFF
ON: Driver door is not closed within 45 sec. after engine switch is turned OFF
OFF: Any status except "ON" status
-
Door Key Related (Open)*
Key-linked sliding roof open operation status/Avail or Not Avail
Avail: Key-linked sliding roof open operation is available
Not Avail: Key-linked sliding roof open operation is not available
-
Door Key Related (Close)*
Key-linked sliding roof close operation status/Avail or Not Avail
Avail: Key-linked sliding roof close operation is available
Not Avail: Key-linked sliding roof close operation is not available
-
Wireless Key Rel (Open)*
Transmitter-linked sliding roof open operation status/Avail or Not Avail
Avail: Transmitter-linked sliding roof open operation is available
Not Avail: Transmitter-linked sliding roof open operation is not available
-
Wireless Key Rel (Close)*
Transmitter-linked sliding roof close operation status/Avail or Not Avail
Avail: Transmitter-linked sliding roof close operation is available
Not Avail: Transmitter-linked sliding roof close operation is not available
-
Door Handle Button Close*
Entry lock switch-linked sliding roof close operation status/Avail or Not Avail
Avail: Entry lock switch-linked sliding roof close operation is available
Not Avail: Entry lock switch-linked sliding roof close operation is not available
-
Door Key Related Operation*
Direction for key-linked operation/Tilt or Slide
Tilt: Key-linked sliding roof operation operates tilt up or down
Slide: Key-linked sliding roof operation operates slide open or close
-
Wireless Key Rel Operation*
Direction for Transmitter-linked operation/Tilt or Slide
Tilt: Transmitter-linked sliding roof operation operates tilt up
Slide: Key-linked sliding roof operation operates slide open
-
Down Switch Failure(Current)
Down switch failure signal (Current)/Fail or Not Fail
Fail: Sliding roof tilt down signal failure (Current)
Not Fail: Sliding roof tilt down signal not fail (Current)
-
Up Switch Failure(Current)
Up switch failure signal (Current)/Fail or Not Fail
Fail: Sliding roof tilt up signal failure (Current)
Not Fail: Sliding roof tilt up signal not fail (Current)
-
Close Switch Failure(Current)
Close switch failure signal (Current)/Fail or Not Fail
Fail: Sliding roof close signal failure (Current)
Not Fail: Sliding roof close signal not fail (Current)
-
Open Switch Failure(Current)
Open switch failure signal (Current)/Fail or Not Fail
Fail: Sliding roof open signal failure (Current)
Not Fail: Sliding roof open signal not fail (Current)
-
Down Switch Failure(Past)
Down switch failure signal (Past)/Fail or Not Fail
Fail: Sliding roof tilt down signal failure (Past)
Not Fail: Sliding roof tilt down signal not fail (Past)
-
Up Switch Failure(Past)
Up switch failure signal (Past)/Fail or Not Fail
Fail: Sliding roof tilt up signal failure (Past)
Not Fail: Sliding roof tilt up signal not fail (Past)
-
Close Switch Failure(Past)
Close switch failure signal (Past)/Fail or Not Fail
Fail: Sliding roof close signal failure (Past)
Not Fail: Sliding roof close signal not fail (Past)
-
Open Switch Failure(Past)
Open switch failure signal (Past)/Fail or Not Fail
Fail: Sliding roof open signal failure (Past)
Not Fail: Sliding roof open signal not fail (Past)
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
- HINT:
- *: w/ Remote Function
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Sliding Roof / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Sliding Roof Tester Display
Test Part
Control Range
Diagnostic Note
Slide Roof
Operate sliding roof SLIDE CLOSE/TILT UP
Clos/Up: Sliding roof SLIDE CLOSE or TILT UP operation occurs
OFF: Sliding roof is not operating
Be careful to avoid injuries as this test causes vehicle parts to move.
Slide Roof
Operate sliding roof SLIDE OPEN/TILT DOWN
Open/Dwn: Sliding roof SLIDE OPEN or TILT DOWN operation occurs
OFF: Sliding roof is not operating
Be careful to avoid injuries as this test causes vehicle parts to move.