REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the LH side and RH side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY |
![]() ![]() |
Detach the 8 claws and remove the opening cover.
| 3. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY |
![]() ![]() |
Remove the 2 bolts.
Remove the speaker and then disconnect the speaker connector.
- NOTICE:
- Do not touch the cone part of the speaker.
| 4. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY |
![]() ![]() |
- HINT:
- Use the same procedure to install the front assist grip on the other side.
Attach the 2 claws to install the front assist grip.
Install the 2 bolts.
Attach the 4 claws to install the 2 assist grip plugs.

| 5. REMOVE FRONT PILLAR GARNISH LH |
![]() ![]() |
for 9, 14 Speakers:
Connect the speaker connector.
Attach the clip and 3 guides to install the front pillar garnish.
| 6. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
Detach the 4 claws and remove the speaker panel.

| 7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
for 9 Speakers Models:

Remove the 2 bolts.
Remove the speaker and then disconnect the speaker connector.
- NOTICE:
- Do not touch the cone part of the speaker.
except 9 Speakers Models:


Remove the 2 bolts.
Remove the speaker and then disconnect the speaker connector.
- NOTICE:
- Do not touch the cone part of the speaker.




