2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

B181912E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws and remove the instrument side panel.


3. REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

B180301E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws.

  1. Disconnect the connector and remove the instrument side panel.


4. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

B180303E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws and remove the No. 3 instrument cluster finish panel garnish.


5. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B180656
  1. Detach the 4 claws and remove the No. 2 instrument panel under cover.


7. REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

B180302
  1. Remove the 2 bolts.

  1. Detach the 4 claws and remove the lower instrument panel.


8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

  1. B189606E01
    Remove the 4 bolts.

  1. Detach the 4 claws and remove the front passenger side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


9. REMOVE INSTRUMENT PANEL BOX DOOR KNOB

B182302
  1. Using a moulding remover, detach the 2 claws and remove the instrument panel box door knob.


10. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

B180304
  1. Remove the 4 bolts.

  1. Detach the 3 claws.

  1. Disconnect the connector and remove the lower No. 2 instrument panel finish panel.


11. REMOVE NAVIGATION MODULE BOARD WITH DISC PLAYER BRACKET

  1. B182282
    Detach the clamp.

  1. Remove the 2 screws and nut.

  1. Disconnect the navigation module board connectors and remove the navigation module board with disc player bracket.


12. REMOVE NO. 2 DISC PLAYER BRACKET

B184305
  1. Remove the 2 screws and bracket.


13. REMOVE NO. 1 DISC PLAYER BRACKET

B184306
  1. Remove the 2 screws and bracket.

← COMPONENTS (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →