TERMINALS OF ECU
System information · Vehicles built from Sep 2011
| CHECK SEAT BELT CONTROL ECU |


Measure the voltage and resistance according to the value(s) in the table below.
- HINT:
- Check from the rear of the connector while it is connected to the seat belt control ECU.
If the result is not as specified, the seat belt control ECU may have a malfunction.Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
E41-2 (MOR+) - E41-8 (PGND)
L - W-B
Passenger side seat belt motor power source line
Ignition switch ON
4 to 8.5 V
E41-3 (MOL+) - E41-8 (PGND)
GR - W-B
Driver side seat belt motor power source line
Ignition switch ON
4 to 8.5 V
E42-8 (IG1) - Body ground
G - Body ground
Seat belt control ECU power source line
Ignition switch ON
11 to 14 V
E41-7 (+B) - Body ground
R - W-B
Seat belt control ECU power source line
Always
11 to 14 V
E41-1 (MOR-) - Body ground
B - Body ground
Passenger side seat belt motor ground line
Ignition switch ON
4 to 8.5 V
E41-4 (MOL-) - Body ground
W - Body ground
Driver side seat belt motor ground line
Ignition switch ON
4 to 8.5 V
E41-5 (PBK+) - Body ground
G - Body ground
Passenger side buckle switch ground line
Always
Below 1 Ω
E41-5 (PBK+) - E41-8 (PGND)
G - W-B
Passenger side buckle switch signal line
Ignition switch ON
Front passenger side seat belt unfastened (Buckle switch off)
Waveform 1
Ignition switch ON
Front passenger side seat belt fastened (Buckle switchs on)
E41-8 (PGND) - Body ground
W-B - Body ground
Seat belt control ECU ground line
Always
Below 1 Ω
Inspect using an oscilloscope.
Waveform 1 (Reference)


Terminal No. (Symbol)
E41-5 (PBK+) - E41-8 (PGND)
Tool Setting
5 V/DIV., 20 ms./DIV.
Switch Condition
Ignition switch ON
Front passenger side seat belt unfastened (Buckle switch off)
Ignition switch ON
Front passenger side seat belt fastened (Buckle switch on)