2011-2013 Land Cruiser · Service Manual Vehicle Interior

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INITIAL CHECK
  1. The initial check occurs when the ignition switch is off for more than 2 seconds, and then turned to ON. The initial check consists of the pre-crash safety system diagnostic check which lasts approximately 3 seconds.

  2. If a malfunction is detected during the initial check, the multi-information display displays "Check PCS System" or "PCS Not available now".

    Warning Message
    Detail
    DTC
    PCS Warning Indicator
    Check PCS System
    This message appears when the seat belt control ECU detects a system malfunction
    DTC is output
    ON
    PCS Not available now
    This message appears when the seat belt control ECU is in the fail-safe mode
    DTC is not output
    Blinking


CONSTANT CHECK
  1. After completing the initial check, the pre-crash safety system will become operational. Then, the diagnosis circuit will perform a constant check to check that there is not a system malfunction.

  2. If a malfunction is detected during the constant check, the multi-information display displays "Check PCS System" or "PCS Not available now".
    E145804E09

← TERMINALS OF ECU (from Sep 2011)DIAGNOSIS SYSTEM (from Jan 2012) →