DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Pre-Crash / Data List.
According to the display on the intelligent tester, read the Data List.
Pre-Crash Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Driver Buckle SW
Driver side buckle switch status / UNSET, SET or NG
UNSET: Driver side seat belt unfastened
SET: Driver side seat belt fastened
NG: Indeterminate data
-
Passenger Buckle SW
Front passenger side buckle switch status / UNSET, SET or NG
UNSET: Passenger side seat belt unfastened
SET: Passenger side seat belt fastened
NG: Indeterminate data
-
Driver Belt Control
Seat belt control status of driver side seat / STOP, ON or ERROR
STOP: Control stopped
ON: Controlled
ERROR: Indeterminate data
Driver side seat belt is fastened
Passenger Belt Control
Seat belt control status of passenger side seat / STOP, ON or ERROR
STOP: Control stopped
ON: Controlled
ERROR: Indeterminate data
Passenger side seat belt is fastened
Number of Trouble Codes
Number of present trouble codes / Min.: 0, Max.: 255
Number of DTCs present
-
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: All ECUs / (desired menu) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Pre-Crash Tester Display
Test Part
Control Range
Diagnostic Note
Driver Seat Belt Motor
Driver side seat belt motor
OFF or ON
Driver side seat belt is fastened
Passenger Seat Belt Motor
Passenger side seat belt motor
OFF or ON
Passenger side seat belt is fastened
Driver and Passenger Seat Belt Motor
Driver and passenger side seat belt motors
OFF or ON
Driver and passenger side seat belts are fastened
ABS/VSC/TRAC Tester Display
Test Part
Control Range
Diagnostic Note
Buzzer
Skid control buzzer sounds
OFF or ON
-