Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit supplies power to the seat belt control ECU when the ignition switch is ON.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Start the engine before inspection. Check the IG1 NO. 1 relay or battery if the starting system does not start.
| 1. INSPECT FUSE (ECU-IG No. 1, PSB) |
 |
Remove the ECU-IG No. 1 and PSB fuses from the main body ECU.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
ECU-IG No. 1 fuse
|
Always
|
Below 1 Ω
|
PSB fuse
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - BATTERY AND BODY GROUND) |
 |
- Disconnect the E41 and E42 seat belt control ECU connectors.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
E42-8 (IG1) - Body ground
|
Ignition switch ON
|
11 to 14 V
|
Ignition switch off
|
Below 1 V
|
E41-7 (+B) - Body ground
|
Always
|
11 to 14 V
|
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E41-8 (PGND) - Body ground
|
Always
|
Below 1 Ω
|
Result
Result
|
Proceed to
|
OK (for LHD)
|
A
|
OK (for RHD)
|
B
|
NG
|
C
|
|
B |
 |
|
|
|
|
C |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| A |
|
 |
|
|