2011-2013 Land Cruiser · Service Manual Vehicle Interior

Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit supplies power to the seat belt control ECU when the ignition switch is ON.

WIRING DIAGRAM

E149049E01

INSPECTION PROCEDURE

HINT:
Start the engine before inspection. Check the IG1 NO. 1 relay or battery if the starting system does not start.


1. INSPECT FUSE (ECU-IG No. 1, PSB)
  1. Remove the ECU-IG No. 1 and PSB fuses from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω
    PSB fuse



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - BATTERY AND BODY GROUND)

  1. E149051E03
    Disconnect the E41 and E42 seat belt control ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E42-8 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    E41-7 (+B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E41-8 (PGND) - Body ground
    Always
    Below 1 Ω

    Result 
    Result
    Proceed to
    OK
    (for LHD)
    A
    OK
    (for RHD)
    B
    NG
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE SEAT BELT CONTROL ECU (Click here)


← U0235 Lost Communication with Cruise Control Front Distance Range Sensor (+ U1102) (from Jan 2012)Power Source Circuit (from Jan 2012) →