2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT FUEL INJECTOR ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11.6 to 12.4 Ω

    If the result is not as specified, replace the injector assembly.

  1. Inspect the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any sparks or flames. Do not smoke.


    1. C157056E14
      Remove the fuel pipe clamp.
      Text in Illustration 
      *1
      Fuel Pipe Clamp

    2. A088336E32
      Disconnect the fuel tube.
      Text in Illustration 
      V100135
      Pinch
      V100136
      Pull

    3. A088228E24
      Connect SST to the fuel pipe (the vehicle side).
      SST
      09268-31012   (09268-41500, 90467-13001, 95336-08070)
      Text in Illustration 
      *1
      SST (Fuel Tube Connector)
      *2
      Fuel Pipe
      *3
      SST (Hose)
      *4
      SST (Clip)

    4. A149192E07
      Install the O-ring to the fuel injector.

    5. Install SST and the tube to the fuel injector.

      SST
      09268-31012   (09268-41300, 09268-41600, 90467-13001, 95336-08070)
      Text in Illustration 
      *1
      O-Ring
      *2
      Tube
      *3
      SST (Clip)
      *4
      SST (Adapter)

    6. A149193E05
      Put the injector into a graduated cylinder.
      Text in Illustration 
      *1
      SST (Wire)

      CAUTION:
      Install a strong rubber tube onto the injector to prevent gasoline from splashing.

    7. Operate the fuel pump (turn the engine switch on (IG)).

    8. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30090  

      Standard injection volume:
      87 to 105 cm3 (5.3 to 6.4 cu in.) per 15 seconds

      Difference between each injector:
      18 cm3 (1.1 cu in.) or less

      If the injection volume is not as specified, replace the injector assembly.

  1. Check for fuel drop.

    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel drop from the injector.

      Standard fuel drop:
      1 drop or less in 12 minutes

      If the fuel drop is not as specified, replace the injector assembly.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →