After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
3.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
4.
REMOVE V-BANK COVER SUB-ASSEMBLY
Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
Text in Illustration
*1
Bracket
*2
Hook
*3
Pin
*4
Grommet
5.
REMOVE AIR CLEANER HOSE ASSEMBLY
Disconnect the vacuum hose and No. 2 ventilation hose.
Loosen the 2 hose clamps.
Remove the air cleaner hose.
6.
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Remove the No. 1 engine cover sub-assembly.
7.
REMOVE NO. 3 ENGINE COVER
Remove the No. 3 engine cover.
8.
DISCONNECT NO. 2 FUEL TUBE
Disconnect the No. 2 fuel tube from the fuel pressure regulator (Click here).
9.
DISCONNECT NO. 1 FUEL TUBE
Disconnect the No. 1 fuel tube from the fuel delivery pipe RH (for metallic type) (Click here).
SST
09268-21011
Text in Illustration
*A
RH Side
LH Side: Disconnect the No. 1 fuel tube from the fuel delivery pipe LH (Click here).
Text in Illustration
*A
LH Side
10.
DISCONNECT NO. 1 FUEL HOSE
Disconnect the No. 1 fuel hose from the fuel delivery pipe LH (Click here).
11.
REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH
Disconnect the ventilation hose and No. 6 wire harness connector.
Remove the 2 bolts and fuel delivery pipe RH.
NOTICE:
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head RH.
12.
REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH
Disconnect the No. 7 wire harness connector.
Remove the 2 bolts and fuel delivery pipe LH.
NOTICE:
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head LH.
13.
REMOVE FUEL INJECTOR ASSEMBLY
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
NOTICE:
For reinstallation, attach a tag or label to the injector shaft.
Remove the O-ring from the fuel injector.
Text in Illustration
*1
O-Ring
Detach the 3 clamps and then remove the No. 6 wire harness from the delivery pipe RH.
Text in Illustration
*A
Fuel Delivery Pipe RH
Detach the 3 clamps and then remove the No. 7 wire harness from the delivery pipe LH.