2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when the IG output circuits inside the main body ECU are open or shorted.
DTC Code
Detection Condition
Trouble Area
B2271
The IG1 No. 3 relay actuation circuit or integration relay (IG2 relay) actuation circuit inside the main body ECU is abnormal.
  1. Main body ECU
  1. AM2 fuse
  1. Harness or connector

WIRING DIAGRAM

C164714E02

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Clear the DTCs (Click here).

  1. Check whether DTC B2271 is output.

    Result 
    Result
    Proceed to
    DTC B2271 output
    A
    No DTC output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. INSPECT FUSE (AM2)
  1. Remove the AM2 fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    AM2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)
A175398E01
  1. Disconnect the E1, E2 and 2D main body ECU connectors.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E1-6 (AM1) - Body ground
    Always
    11 to 14 V
    E2-1 (AM2) - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2D-62 (GND2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Jan 2012)B2271 Ignition Hold Monitor Malfunction (from Jan 2012) →