B2271 Ignition Hold Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when the IG output circuits inside the main body ECU are open or shorted.| DTC Code |
Detection Condition |
Trouble Area |
| B2271 |
The IG1 No. 3 relay actuation circuit or integration relay (IG2 relay) actuation circuit inside the main body ECU is abnormal. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Clear the DTCs (Click here).
Check whether DTC B2271 is output.
Result Result
Proceed to
DTC B2271 output
A
No DTC output
B
|
|
||||
| A | |
| 2. INSPECT FUSE (AM2) |
Remove the AM2 fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
AM2 fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |


Disconnect the E1, E2 and 2D main body ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E1-6 (AM1) - Body ground
Always
11 to 14 V
E2-1 (AM2) - Body ground
Always
11 to 14 V
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2D-62 (GND2) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
