B2284 Brake Signal Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when there is an inconsistency between the circuit between the main body ECU and stop light switch, and the CAN communication signal between the main body ECU and ECM.| DTC No. |
Detection Condition |
Trouble Area |
| B2284 |
The circuit between the main body ECU and stop light switch, and the CAN communication signal between the main body ECU and ECM are inconsistent. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Use the Data List to check if the stop light switch is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Light SW
Stop light switch/ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Result Result
Proceed to
Display on the intelligent tester does not change according to brake pedal operation
A
Display on the intelligent tester changes according to brake pedal operation
B
|
|
||||
| A | |
| 2. INSPECT FUSE (STOP) |
Remove the STOP fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
STOP fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT STOP LIGHT SWITCH |
![]() ![]() |
Disconnect the A30 stop light switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Stop light switch pin not pushed
Below 1 Ω
3 - 4
Stop light switch pin pushed
Below 1 Ω
1 - 2
Stop light switch pin pushed
10 kΩ or higher
3 - 4
Stop light switch pin not pushed
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND STOP LIGHT SWITCH) |


Disconnect the 2B main body ECU connector.
Disconnect the A30 stop light switch connector.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
A30-2 - Body ground
Always
11 to 14 V
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2B-22 (STP) - A30-1
Always
Below 1 Ω
2B-22 (STP) or A30-1 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||

