CHECK MODE PROCEDURE
Troubleshooting · Vehicles built from Sep 2011
- NOTICE:
- Enter "Signal Check" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).
- HINT:
- DTCs can be stored more sensitively in check mode than in normal diagnosis mode.
- Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.
- DTCs can be stored more sensitively in check mode than in normal diagnosis mode.
| CHECK MODE PROCEDURE (for Using an Intelligent Tester) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Utility / Signal Check / *.
- HINT:
- *: Follow the directions on the tester screen.