DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Data List.
According to the display on tester, read the Data List.
Center Airbag Sensor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Driver Seat Position
Driver Seat Position/
FORWARD: Seat position is forward
BKWARD: Seat position is backward
FAIL: Failure detected
FORWARD/BKWARD
-
Passenger Detection
Passenger Detection/
NG: Data is not determined
OFF: Vacant
NONE: No passenger
DETECT: A passenger is seated
FAIL: Failure detected
NONE/DETECT
-
Right Side Buckle SW
Right Side Buckle SW/
UNSET: The seat belt is not fastened
SET: The seat belt is fastened
NG: Data is not determined
UNSET/SET
-
Left Side Buckle SW
Left Side Buckle SW/
UNSET: The seat belt is not fastened
SET: The seat belt is fastened
NG: Data is not determined
UNSET/SET
-
Display Type Information
Display Type Information/
LR: The display is indicated by LH/RH
DP: The display is indicated by Driver/Passenger
LR
-
Number of Past DTC
Number of Past DTCs/
Min.: 0, Max.: 255
0
-