FREEZE FRAME DATA
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| FREEZE FRAME DATA |
Whenever a DTC is stored, the skid control ECU (master cylinder solenoid) stores the current vehicle (sensor) state as freeze frame data.
The skid control ECU (master cylinder solenoid) stores the number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the ABS/VSC was activated.
- HINT:
- If the vehicle is stopped or at a low speed (7 km/h (4 mph) or less), or if a DTC is stored, the skid control ECU (master cylinder solenoid) will stop counting the number of times the ignition switch has been turned from off to ON.
- Freeze frame data at the time the ABS/VSC operates:
The skid control ECU (master cylinder solenoid) stores and updates data whenever the ABS/VSC operates.
When the ECU stores data at the time a DTC is stored, the data stored during ABS/VSC operation is cleared.
- Freeze frame data at the time a DTC is stored:
When the skid control ECU (master cylinder solenoid) stores data at the time a DTC is stored, no updates will be performed until the data is cleared.
- If the vehicle is stopped or at a low speed (7 km/h (4 mph) or less), or if a DTC is stored, the skid control ECU (master cylinder solenoid) will stop counting the number of times the ignition switch has been turned from off to ON.
| CHECK FREEZE FRAME DATA |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
According to the display on the GTS, select the trouble code data display with freeze frame data.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Elapsed Time after Freeze Trigger
Elapsed time after freeze trigger/ Min.: 0 msec, Max.: 500 msec
-
-
Number of IG ON
Number of times ignition switch turned to ON after storing freeze frame data/ 0 to 31
-
-
Buzzer
Buzzer/ ON or OFF
ON: Buzzer on
OFF: Buzzer off
The combination meter has a built-in buzzer.
Stop Light SW
Stop light switch/ ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch/ ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Reservoir Warning SW
Brake fluid level warning switch/ ON or OFF
OFF
-
Gear Position
Gear position information/ P,N, R, 1st-8th, Fail or Not R
Actual gear position
-
Shift Lever Position
Shift lever position information/ P,N, R, D/M, 1st-6th/B or Fail
Actual shift lever position
-
Operated System
Operated system status/ ABS, VSC, TRC, BA, HAB, PBA, PB, HA-CTRL, Fail, TSC, Sys or Non
-
ABS: ABS is activated.
VSC: VSC is activated.
TRC: TRC is activated.
BA: BA is activated.
PBA: PBA is activated.
PB: PB is activated.
HA-CTRL: Hill-start assist control is activated.
Fail: Fail safe mode is activated.
Non: No operation is activated.
Master Cylinder Sensor
Master cylinder pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
When brake pedal released: 0.3 to 0.9 V
The value increases when the brake pedal is depressed.
M/C Sensor Grade
Master cylinder pressure sensor change/ Min.: -30 MPa/s, Max.: 225 MPa/s
When brake pedal released or pedal held at constant position: 0 MPa/s
Changes in proportion with the pedal movement speed when the brake pedal is being operated.
Yaw Rate Sensor
Yaw rate sensor/ Min.: -128°/s, Max.: 127°/s
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Lateral G
Lateral G/ Min.: -25.10 m/s2, Max.: 24.90 m/s2
-
Changes in proportion with the pedal movement speed when the brake pedal is being operated.
Forward and Rearward G
Forward and backward G/ Min.: - 25.10 m/s2, Max.: 24.90 m/s2
-
Changes in proportion with acceleration during acceleration/deceleration.
FR Wheel Speed
Front wheel speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
FL Wheel Speed
Front wheel speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
RR Wheel Speed
Rear wheel speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
RL Wheel Speed
Rear wheel speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
Vehicle Speed
Maximum wheel speed sensor reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
Vehicle Speed Grade
Vehicle acceleration/ Min.: -25.10 m/s2, Max.: 24.90 m/s2
Vehicle stopped: 0 m/s2
Changes in proportion with the vehicle acceleration/deceleration during driving.
FR Wheel Direction
Front wheel RH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
FL Wheel Direction
Front wheel LH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
RR Wheel Direction
Rear wheel RH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
RL Wheel Direction
Rear wheel LH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
Real Engine Torque
Actual engine torque/ Min.: -1024.0 Nm, Max.: 1023.0 Nm
-
-
Accelerator Opening Angle %
Throttle valve opening amount/ Min.: 0.0%, Max.: 128.0%
When accelerator pedal released: 0%
Changes in proportion with the movement of the pedal during accelerator pedal operation.
Steering Angle Sensor
Steering sensor/ Min.: - 3276.8°, Max.: 3276.7°
Left turn: Increase
Right turn: Decrease
-
Pre Crash Brake OFF Switch*
Pre-crash system cancel switch/ ON or OFF
-
-
TRC/VSC Off Mode
TRC/VSC off mode/ Normal, TRC OFF or VSC OFF
Normal: Normal mode
TRC OFF: TRC off mode
VSC OFF: VSC off mode
-
- *: w/ Dynamic Radar Cruise Control System
- *: w/ Dynamic Radar Cruise Control System
| CLEAR FREEZE FRAME DATA |
- NOTICE:
- Clearing the DTCs will also clear the freeze frame data.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs and freeze frame data (Click here).