VSC Buzzer Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The skid control ECU (master cylinder solenoid) is connected to the combination meter via CAN communication.The combination meter has a built-in buzzer.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).
| 1. CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
- OK:
- "CAN Bus Check" indicates no malfunctions in CAN communication.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Check for DTCs (for LHD: Click here, for RHD: Click here).
Result Result
Proceed to
CAN system DTC is not output
A
CAN system DTC is output (for LHD)
B
CAN system DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 3. PERFORM ACTIVE TEST USING GTS (BUZZER) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
Buzzer
Buzzer
Buzzer ON/OFF
The buzzer can be heard.
When performing the Buzzer Active Test, check Buzzer in the Data List (Click here).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Buzzer
Buzzer/ ON or OFF
ON: Buzzer on
OFF: Buzzer off
The combination meter has a built-in buzzer.
Result Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Changes between ON and OFF
A
Does not change between ON and OFF
B
OFF
Changes between ON and OFF
A
Does not change between ON and OFF
B
|
|
||||
| A | ||
| ||
| 4. INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
Result Result
Proceed to
NG (w/ Multi-information Display)
A
NG (w/o Multi-information Display)
B
OK (for LHD)
C
OK (for RHD)
D
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
