2011-2013 Land Cruiser · Service Manual Steering

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the following procedures to troubleshoot the variable gear ratio steering system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (for LHD)
      B
      DTC is output (for RHD)
      C


    B.

    C.
    A

    4.CHECK DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).

      1. Simulate the malfunction and check if the DTCs are output again (Click here).

        Result 
        Result
        Proceed to
        DTC is output
        A
        DTC is not output
        B
        DTCs are not output, and the malfunction cannot be simulated or checked.
        C


    B.

    C.
    A

    5.DTC CHART
      NEXT

      6.CIRCUIT INSPECTION
        NEXT

        7.REPAIR
          NEXT

          8.CONFIRMATION TEST
            NEXT

            9.PROBLEM SYMPTOMS TABLE
              NEXT

              10.CIRCUIT INSPECTION
                NEXT

                11.CONFIRMATION TEST
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)INITIALIZATION (from Sep 2011) →